Home » Archive by categoryMechanical Engineering (Page 16)

## Mass Moment of Inertia

Definition: It has been established since long that a rigid body is composed of small particles. if the mass of every particle of a body is multiplied by the square of its perpendicular distance from a fixed live, then the sum of these quantities (for the whole body)...
Continue reading

## Torque

Definition: It may be defined as the product of force and the perpendicular distance of its line of action from the given point or axis. A little consideration will show that the torque is equivalent to a couple acting upon a body.
Continue reading

## Kinematic Link or Element

Definition: Each part of a machine, which moves relative to some other part is known as a kinematic link ( or simply link ) or element. A link may consists several parts, which are rigidly fastened together, so that they don’t move relative to on an other. Types...
Continue reading

## Types of Links

In order to transmit motion, the driver and the follower may be connected by the following three types of links. 1. Rigid Link: A rigid link is one which does not undergo any deformation while transmitting motion, strictly speaking rigid links do not exists. However, as the deformation...
Continue reading

## What is Structure? (Definition)

Definition: It is an assemblage of a number of resistance bodies (known as member) having no relative motion b/w them and meant for carrying loads having straining action. A railway bridge, a roof trues machine frames etc are the example of structure.
Continue reading

## Difference between a Machine and a Structure

The following differences between a machine and a structure are important from the subject (Machine Design) point of view.   1. The parts of machine move relative to one another, whereas the members of a structure do not move relative to one another. 2. A machine transforms the...
Continue reading

## Kinematic Pair (Definition)

Definition: The two links or elements of a machine, when in contact with each other are said to form a pair. If the relative motion between them is completely or successfully constrained (i.e. in a definite direction) the pair is known as kinematic pair. source: Thermodynamics by Youns...
Continue reading

## Classifications of Machine Design

The machine design may be classified as follows : 1. Adaptive design. In most cases, the designerâ€™s work is concerned with adaptation of existing designs. This type of design needs no special knowledge or skill and can be attempted by designers of ordinary technical training. The designer only...
Continue reading

## General Considerations in Machine Design

General Considerations in Machine Design Following are the general considerations in designing a machine component: 1. Type of load and stresses caused by the load. The load, on a machine component, may act in several ways due to which the internal stresses are set up. 2. Motion of...
Continue reading

## Electromechanical systems

Electromechanical systems In the design of any complex system, all the relevant design details must be considered to ensure the development of a successful product. In the development of motion systems, problems in the design process are most likely to occur in the actuator or motor-drive system. When...
Continue reading